$195.00
Item #: VSURECTRL
Please note this is the control for existing VentSure, Genesis or DynaTrol vent systems. Actual vent sold separately.
This new vent control allows you to automatically control the operation of the Vent-Sure kiln vent with one of the outputs from a DynaTrol or Genesis controller.
Where It Can Be Used
It is only available for kilns with a DynaTrol or Genesis. (Not available on the One-Touch).
It may not be used with kilns with powered bottoms (because the same output on the control is used)
One Vent Control can control between 1-4 vents on a single kiln (if the kiln requires more than one vent).
The Vent Control is only available for 120-volt vents.
Operation
NOTE: These options are set in the "Hidden Menu".
OPTION A (OP A)
Used to control a vent. Output 4 can be programmed to be on or off during each segment of a Vary-Fire program. During an Easy-Fire program, output 4 comes on at the beginning of the firing and turns off after the kiln has cooled to 150 F.
OPTION B (OP B)
Used to control a vent. Output 4 can be programmed to be on or off during each segment of a Vary-Fire program. Output 4 comes on at the beginning of an Easy-Fire program, off at 1450 F, back on after the firing is complete and the kiln has cooled to 1000F and finally off again when the temperature is below 150F.
OPTION C (OP C)
Used to control a vent, an alarm, or other atmospheric control. Output 4 can be programmed to be on or off during each segment of a Vary-Fire program. Output 4 is off during Easy-Fire programs.
L&L Item M-V-CNTL/PT